Beta 1838SW Manual De Uso E Instrucciones página 6

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
TECHNICAL DATA
MAIN LIGHT
TOP LIGHT
BATTERY SPECIFICATIONS
POWER SUPPLY VOLTAGE
CHARGE INPUT
PROTECTION DEGREE
OPERATING TEMPERATURE
USE
Before using the lamp for the first time, select the operating mode as follows:
- Press the ON/OFF switch to enable the lamp.
- Press once to enable the TOP light.
- Press a second time to enable the MAIN light in the eco mode.
- Press a third time to switch the lamp to the normal mode.
- Press a fourth time to switch the lamp to the full power mode.
- Pressing a fifth time will cause the lamp to be disabled and switched off.
After the lamp has been on for 5 seconds in the selected mode, pressing the ON/OFF switch will cause it to be SWITCHED OFF.
When the lamp is enabled again by pressing the ON/OFF switch, it will go on in the last selected mode.
The lamp is fitted with 3 magnets for adhering to metal surfaces and 2 articulated hooks for hanging.
CHARGING MODE
Lamp charge with wireless charging base 1839BRW
- The lamps must be charged when off.
- Place the back of the lamp to charge on one of the two slots of the wireless charging base, 1839BRW, making the magnet
fit the slot.
- While the lamp is charging, its LED charge indicators flash.
- When the lamp is fully charged, the 3 LEDs turn solid green.
- When charge is completed, the lamp can be disconnected from the wireless battery charger.
Lamp charge through USB
- To charge the lamp, lift the USB port cover on the back of the lamp.
- Connect the cable first to the lamp and the power supply, and then to the mains socket, making sure that the mains voltage
is compatible with that of the charger as stated in the TECHNICAL DATA table.
- While the lamp is charging, its LED charge indicators flash.
- The lamp will be fully charged when the 3 LED lights will remain green.
- When the lamp is fully charged, disconnect it from the power supply and close the USB port cover.
Charge level
Turning the lamp on will cause 3 LED charge indicators to light up.
- 3 green LED lights: 100% charge
- 2 green LED lights: 60% charge
- 1 green LED light: 20% charge
- Blinking LED light: flat battery
If the battery is flat, both the light being used and the LED charge indicator will be blinking.
6
COB LED 10W 6.500K
eco mode ~ 250 lm - max 5h
normal mode ~ 500 lm - max 2.5h
full power mode ~ 1000 lm - max 1.3h
SMD LED 4W 6.500K
~200 lm - max 5h
Li-Ion 3.7 V, 3350mAh
100 - 240V ~ 50/60Hz
DC 5V -1A (USB-C)
IP65 IK09
-10°C ÷ +40°C
EN I