Publicidad
Idiomas disponibles
Idiomas disponibles
HTF337 OPERATION (CONTINUED)
To activate Wide Area Oscillation feature, press the Oscillation
button once ( ). Press the Oscillation button again to turn the
Oscillation feature off. (Fig. 4)
To activate the Auto-Off Timer option choose from 1, 2, 4 or 8 hour
settings by pressing the Timer ( ) button. (Fig. 5)
For 1 hour: Press the Timer button ( ) once.
For 2 hours: Press the Timer button ( ) twice.
For 4 hours: Press the Timer button ( ) a third time.
For 8 hours: Press the Timer button ( ) a fourth time.
Press the Timer button a fifth time to turn the Timer feature off.
To move the fan, turn the fan OFF and pick it up by the integrated
carry handle located on the back of the fan. (Fig. 6)
LED Auto Dim feature: LEDs will fade from their current brightness
to 0% brightness after 15 seconds. The lights will return to
brightness once any button is pressed on the control panel.
CLEANING INSTRUCTIONS
CLEANING AND STORAGE
Turn the fan OFF and unplug it before cleaning.
Use only a soft cloth or cotton swab to gently wipe the fan clean.
DO NOT immerse the fan in water and NEVER allow water to drip into the
motor housing.
DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
REMOVAL OF THE FRONT GRILLE FOR CLEANING. DO NOT
remove the fan grille unless the power is turned OFF and the power
cord is unplugged.
Remove the 3 screws located on the back of the rear grille. (Fig. 7) Use a standard Philips head screwdriver
and rotate counter-clockwise to remove the screws.
NOTE: Screwdriver head should fit comfortably in the hole without being too tight or leaving too much
room. A screwdriver with a head that is too small will have trouble engaging the screw.
NOTE: Screws will sometimes fall out of the back of the unit once loosened, so be sure not to stand the
fan up or tip it over too quickly.
4
4
5
6
7
Publicidad
