Publicidad
Idiomas disponibles
Idiomas disponibles
Notes:
During prolonged operation, the saw might be auto-
matically switched off to protect the motor against dam-
age from overheating.
6 and wait until the cut-out is
–
Release the switch
automatically reset.
The electronic speed control of the machine features a
motor protection function. It prevents the motor against
damage from overcurrent.
If the overcurrent protection is triggered:
–
Reduce cutting pressure.
Changing saw band
The teeth of the saw band are sharp. Al-
ways wear protective gloves to prevent
injury.
Removing saw band (fig. VI)
–
Switch off main motor switch
–
Release the clamping lever
band guides 10 as closely together as possible.
–
Tighten the clamping lever
–
Loosen and remove the four securing bolts
the guard.
–
Remove the guard.
5 anticlockwise to release the
–
Turn the hand wheel
saw band.
–
Carefully remove the saw band from the saw band
guides 10.
–
Then carefully pull the saw band from the rubber-
coated rollers.
Installing saw band (fig. VI)
The machine is designed for operation in
clockwise direction.
When installing a saw band, ensure that
the teeth are facing in the correct direction.
–
Carefully insert the saw band between the saw
band guides 10.
–
Carefully place the saw band on the rubber-coat-
ed rollers.
–
Turn the hand wheel
5 clockwise until the coupling
is released.
–
Secure the guard with the
–
Allow the saw band to run in properly.
13 (position <0>).
9 and slide the saw
9.
27 of
4 securing bolts 27.
Accessories
For large solid parts or thin-walled profiles and angles,
we offer saw bands with various tooth pitches.
Material: M42 (spring steel + HSS steel)
For dimensions, see <Metal saw data>.
Cleaning and maintenance
‰
Before carrying out any work on the metal saw,
switch off the main motor switch.
‰
For safe working, always keep the machine
clean and ensure that the ventilation slots are un-
blocked.
Under extreme conditions, conductive
dust might enter the machine housing
when metal is cut. This might interfere
with the insulation of the saw. When cut-
ting metal under extreme conditions,
regularly blow out the ventilation slots.
The metal saw has been produced according to best
practice and extensively tested at the factory. In the un-
likely event of a failure, have it examined and repaired
by a Würthmaster-Service Workshop. In Germany, call
0800-WMASTER (0800-9 62 78 37) to contact the
Würthmaster Service. In Austria, call 0800-20 30 13.
In all your queries and spare part orders, always quote
the product number (see type plate) of your machine.
The current spare parts list of the machine can be
viewed online at http://www.wuerth.com/partsman-
ager. Alternatively, contact your local Würth agency
for a hardcopy.
Spare parts
Only use original spare parts. The use of parts from
suppliers other than WÜRTH might cause damage to
the equipment.
17
Publicidad
