Beper 50.160 Manual De Instrucciones página 9

Vertical Steamer Use instructions
Product description Fig.A
1. Water tank
2. Nylon brush
3. Trousers clip
4. Steam button
5. Steam light
6. Clothes brush
Use
Remove water tank.
Lift the plastic cap on the top.
Use a small funnel to pour water and be careful not to exceed the MAX level. If water leaks from the tank, be
careful and dry it well before connecting it to the product.
Reclose the plastic cap.
Place the tank on the product and be careful to insert the small tab located at the bottom in the appropriate hole
and make sure to hear a little "click".
Turn on the product by connecting it to the power outlet. The steam light will turn on, to switch off after about 15
seconds, when the stem will be ready.
At this point you can start ironing by pressing the steam button.
Clothes ironing
Hang the dress and hold it with one hand while with the other press the steam button. Slide the product from top
to bottom to proceed with ironing.
Trousers ironing
To iron trousers with fold, apply the "trouser clip" accessory by inserting it into the appropriate housing. Press
the lever and insert the trousers between the clip and the product and start releasing the steam with movements
from right to left or vertical.
Nylon brush
This accessory can be used to refresh fabrics and remove lint.
Sterilize
Thanks to the high steam temperature, this appliance can also be used to sterilize and / or sanitize fabrics.
Attention: to avoid limestone formation, it is advisable to empty the tank after each use and press the
steam button until it is completely empty.
Technical data
Power: 1300W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
9
EN