Boneco THERA PURE TP450 Manual página 24

24
en
INSERTING A NEW UV LAMP
1. Remove the new UV lamp from the packaging
and make sure you only touch the ends of it.
2. Insert both ends into the BONECO TP450 and ro-
tate the UV lamp counterclockwise as far as it will
go.
3. Make sure the holder is fastened correctly.
4. Put the appliance back together by following the
steps in reverse order.
5. Connect the BONECO TP450 to the power outlet.
6. Switch on the BONECO TP450.
7. Press and hold the button for the performance
control for about 5 seconds until the UV warning
signal on the display goes out.
REPLACEMENT UV LAMP
You can obtain a new UV lamp from your BONECO
specialist dealer or the BONECO online store at
www.envion.com/en/tpp2400.