Publicidad
Idiomas disponibles
Idiomas disponibles
6. Device addition and network configuration
1- This device can only work with a 2.4GHz Wi-Fi signal. So plea-
se check your router and make sure it works at 2.4GHz. When set-
ting up the network, please keep the product and mobile phone as
close as possible to the wireless router to ensure a good network
signal.
2- Please perform the following steps 1-4 in strict order.
3- In the process of network configuration, if you hear the host
message "configure network timeout" or the interface shows that
the network configuration fails, please exit the application and res-
tart the product, and then operate again from step 1.
Step 1: Open and log in the application, click "add device" and
select "Camera & Lock" in the product catalogue on the left, as
shown in (figure 1). Then select "Smart doorbell" in the product
type on the right, and the interface will appear as shown in (figure
2).
13
1
2
EN
Publicidad
