BS BATTERY BST 1000 Manual De Usuario página 5

ACCESSORIES INCLUDED
1x Tester case.
1x USB cable to connect the tester to the computer (for printing).
1x User Manual.
COLD CRANKING AMPS MEASURE RANGE
Lithium Ion Battery
Measure
Standard
CCA
BCI
CA
MCA
JIS
DIN
IEC
EN
SAE
GB
OPERATION AND TEST
Ensure that the area is well ventilated before performing a test.
Make sure that the battery connections are clean. If necessary, clean them using a wire
brush. Any presence of oxidation between the tester terminals and the battery connectors
or between the battery connectors and the battery terminals reduces the effectiveness
of the tester.
If the battery is out of the vehicle:
Connect the negative plug (black) to the negative terminal of the battery.
Connect the positive plug (red) to the positive terminal of the battery.
If the battery is in the vehicle:
As there may be some electricity between the generator and the battery, called floating
electricity, if the battery tester is connected directly to the battery, only the floating power
will be tested, not the power inside the battery, so the result is inaccurate.
Therefore, before connecting the tester to the battery, it is better to ignite first, turn on
the headlights to remove the floating electricity. After that make sure that the ignition
and the consumers are switched off.
Connect the negative plug (black) to the negative terminal of the battery.
Connect the positive plug (red) to the positive terminal of the battery.
| www.bs-battery.com
Measure Range
20-1000
100-2000
20-1000
20-1000
26A17—150F51
20-700
20-700
20-1000
20-1000
2-120
Regular Flooded,
AGM Gel battery, EFB
Measure
Standard
CCA
BCI
CA
MCA
JIS
DIN
IEC
EN
SAE
GB
Measure Range
20-2000
100-2000
20-2000
20-2000
26A17--245H52
20-1400
20-1400
20-2000
20-2000
2-220
5