A&D Medical UC-352BLE Manual De Instrucciones página 18

Specifications
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate the equipment. This transmitter
must not be co-located or operated in conjunction with any other antenna or trans-
mitter. This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines as this equipment has very low levels of RF energy. But it is desirable
that it should be installed and operated keeping the radiator at least 20cm or more
away from person's body.
Industry Canada
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This
transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
Note: This equipment has been tested and found to comply with Industry Canada
rules as a Bluetooth
(2400-2483.5 MHz under IC ID 772C-LBVZ.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
•
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
•
device modular approval spread/spectrum/digital device
®
E-17