Hisense AW0823TW1W Instrucciones De Instalacion Y Uso página 12

Installation (continued)
5
Attaching Side Curtains to Window
□
Pull the left-hand side curtain out until it fits into the window
channel.
□ Use a 1/8 inch (3 mm) drill bit to drill a starter hole through
the hole in the curtain housing (B) .
□ Insert one of the 3/4 inch (19 mm) screws (C) through the
left-hand curtain housing (B) and into the window sash (A).
□ Repeat for the right-hand curtain.
A A
B B
C C
NOTE: The remaining steps on this page are only
applicable for E-star models,with E-star LOGO on the control
panel.
□ Put one EVA foam (JJ) on the curtain housing.
□ In order to minimize air leaks and ensure optimal
insulation, it is necessary to install the EVA Foam (JJ) on
the curtain housing.
□ After the unit is installed to the window, measure the inner
width of the side curtain as shown.
□ Remark a line on the EVA foam (JJ) according to less 1 /8
inch (3 mm) than the measured width, then cut the EVA
foam (JJ) along the line.
□ Remove the backing from the EVA foam (JJ). Attach one
EVA foam (JJ) on the curtain housing (A), the side with
adhesive should facing the curtain housing.
A
JJ
□ Repeat for the left-hand curtain.
12
JJ
A
JJ