Iluminarc LOGIC Drive 2X Guía De Referencia Rápida página 5

LΩGIC Wall Controller
Each LΩGIC Drive 2X comes with a wall-mounted control panel (LΩGIC Wall Controller) which can plug into the RJ12
connector on the back of the product. Download the User Manual from
• Buttons 1–8 trigger playback of the corresponding recorded programs.
• Buttons 9 and 10 decrease and increase the brightness of the connected LOGIC products.
• 5-bit DIP switches set the address of the LΩGIC Wall Controller.
1–8
9 10
DMX Linking
The LΩGIC Drive 2X will work with a DMX controller using a 5-pin phoenix connector. A DMX Primer is available from
www.iluminarc.com.
DMX Connection
The LΩGIC Drive 2X provides a DMX 512 connection using a 5-pin phoenix connector. See the User Manual for
information about connecting and configuring the product for DMX operation.
DMX Output
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The LΩGIC Drive 2X supports RDM protocol that allows feedback to make changes to menu map
options. Download the User Manual from
Signal Connection
The LΩGIC Drive 2X can link to controller software using an Ethernet connection. If using other Art-Net™ or sACN -
compatible products with the LΩGIC Drive 2X, you can control each individually on a single network. See the User
Manual for information about how to connect and configure the product for these signals.
Art-Net Connection
™
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount of DMX512 data using an RJ45
connection over a large network. An Art-Net™ protocol document is available from www.iluminarc.com.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN compatible network.
LΩGIC Drive 2X QRG Rev. 7
QUICK REFERENCE GUIDE
1. Ground
2. Data 1 -
3. Data 1 +
4. Not used
5. Not used
www.iluminarc.com
www.iluminarc.com
Signal Connector
for more details and an RDM chart.
for more information.
EN
3