Hilti UH 700 Manual De Instrucciones Original página 19

10 Troubleshooting
Trouble or fault
Product does not start.
Product does not develop full
power.
The drill bit makes no
progress.
Drill bit does not rotate.
11 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
12 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
13 Further information
For more information on operation,
qr.hilti.com/manual/?id=273762
This link is also to be found at the end of the operating instructions, in the form of a QR code.
Mode d'emploi original
1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
*273762*
Possible cause
Interruption in the electricity supply
The supply cord or plug is defec-
tive.
Electronic fault
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The control switch is not fully
pressed.
Product has been set to reverse
rotation.
Drill bit blunt or damaged.
Chuck not tightened securely.
technology,
273762
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Have the parts checked by a
trained electrical specialist and
replaced if necessary.
▶ Have the parts checked by a
trained electrical specialist and
replaced if necessary.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Press the control switch as far
as it will go.
▶ Set the product to forward
rotation.
▶ Sharpen the drill bit or replace
it.
▶ Tighten the chuck.
environment and recycling, follow this link:
Français 11