NAIM 300 Serie Manual De Instrucciones página 9

Now the source component can be turned on by pressing the
NPX 300 standby button. If the NPX 300 is powering a source
component capable of doing so pressing its standby button will also
switch the units on.
300
4. Series Power Supply NPX 300
Installation and Operation
The NPX 300 performs best when installed on a dedicated equipment stand
such as the Naim Fraim and should be in its final location before connecting
cables or switching on. If upgrading your system with a power supply, ensure
that preamplifiers and power amplifiers are switched off before connecting the
power supply. The NPX 300 standby button is located on the front panel and
will perform the same function as the standby button on a connected 200 or
300 Series Naim product.
The NPX 300 is heavy and care should be taken when lifting or moving it.
Make sure that the surface it is to be placed on can support the full weight.
4.1 Installation – Type 3 And Type 4 Devices
The NPX 300 is a new design of power supply, able to be connected to any
200 Series or 300 Series Naim Audio source product. The NPX 300 supports
operation of a low power, <0.5W standby mode and network standby mode
with these products. Logo brightness is also synchronised from the connected
device.
To install, power off your 200 Series or 300 Series product and remove both
the link plugs.
Connect the Type 3 and Type 4 cables supplied with the NPX 300 to the
device. Ensure the end of the cable marked with one or two bands is connected
to the source unit to maintain the cable directionality.
6