Publicidad
Idiomas disponibles
Idiomas disponibles
1 Floor brush
4 Power switch
7 Dust bin lid opening button
INSTALL THE ACCESSORIES
1. Install the crevice nozzle
You can use the vacuum cleaner with the multifunction nozzle (8), to
reach the most difficult corners, under furniture, for cleaning the
upholstery (sofa, bed, armchairs) or for cleaning the car.
Proceed with the installation of the nozzle (8) directly to the power unit
as shown in Fig 1. To remove the nozzle, press release button (3) and pull.
2. Installare Telescopic tube and floor brush
Use the telescopic tube (2) to connect the floor brush (1).
Insert the tube (2) in the suction hole until blocking, then connect the
brush (1) to the lower part of telescopic tube (2).
You can always extend the telescopic tube as desired, acting on button
(6). To remove the tube, press release button (3) and pull.
3. Install the dust bin
Align the arrow marked on the motor housing with the "unlock" symbol you see on dust container.
Rotate clockwise until block.
4. Remove the dust bin
Press release button (3) and at the same time rotate anti-clockwise, unitl the arrow marked on the motor
housing is aligned with the "unlock" symbol you see on dust container.
Pull the dust container away from motor housing.
SWITCH ON THE UNIT
-
Connect the plug. Take the product in your hand and turn it on by pressing the button (4).
-
Always turn off the appliance before unplugging and putting it away.
CAUTION: the vacuum cleaner is powerful. Hold it firmly to prevent it from falling causing damages
or personal injury.
EMPTY THE CONTAINER
In order to ensure the best performances and having no losses in the air flow and
cleaning power, periodically drain the container.
CAUTION: before emptying and/or start cleaning the dust bin, unplug the unit
from the main electrical outlet.
To empty the container, bring the product above a bin and press the release button (7)
as shown in Figure 3. This button will open the door dropping all the dirt. It is
recommended to do this outdoors to avoid soiling the house when the dust comes out of the trash. Close the
lid.
CLEANING FILTERS
This vacuum cleaner is equipped with a metallic filter (a) and 1 HEPA filter (b),
capable of retaining particles and small organisms such as mites and pollens. In this
way the air re-emitted from the cleaner will be more healthy and clean. To maintain
the performance of the vacuum cleaner is recommended to clean the filters regularly.
- Release the container (5) as described in the previous paragraph.
- Open the lid with the button (7). Extract the filter rotating clockwise.
2 Telescopic tube
5 Dust bin
8 Crevice nozzle
3 Telescopic tube release button
6 Telescopic tube length button
9 Dust container Release button
12
Publicidad
