Thulos TH-SH120 Manual De Instrucciones página 9

USE INSTRUCTIONS.
- The first thing is to have the machine with the battery charged.
- Prepare the face by first cutting the long hairs with a clipper.
- Once the face is free of long hairs, proceed to shave.
- Turn on the machine.
- Go through all areas of the face, stretching the skin with the other hand.
- Press very lightly or not, the machine to the face according to the progress of the shave.
- When the desired shave is achieved, turn off the machine.
- For sideburn trimming, open the sideburn trimmer at the back.
- Turn on the machine and trim the sideburns.
- Turn off the machine, clean the sideburn trimmer by removing any remaining hair with the brush.
- Close the sideburn trimmer.
- Clean the machine and save.
WARNINGS.
The first few times you use the machine, your skin may be slightly irritated. This is normal.
Use the machine regularly, 2 times a week until your skin adapts little by little.
This machine is for get the perfect shave.
This machine is not for trimming.
If you try to shave hair that is too long, the machine will not cut that hair.
You will have to cut your hair first with a hair clipper and then with this machine
shave until you get the perfect close.
CLEANING AND MAINTENANCE.
- Always clean the machine after each use.
- Never put the machine under the tap or wet it.
- Open the shaving head and remove any remaining hair with the cleaning brush.
- Close the shaving head.
- Start the machine and add 2 drops of lubricating oil to each roller.
- Wait a few seconds for the rollers to lubricate and turn off the machine.
- If you have used the rear trimmer, do the same operation.
- Open the sideburn trimmer and remove any remaining hair with the cleaning brush.
- Put the machine into operation and pour a few drops of lubricant on the blades.
- Wait a few seconds, turn off the machine and close the trimmer.
- Put the top cap on the shaving head.
- Clean the outside with a soft cloth.
- In case of low battery, also charge the battery before storing.
- Store the machine if possible in its box, in a dry and dust-free area.