A.
B.
D.
E.
F.
CAPABILITIES
Will shred: Paper, plastic credit cards*, staples* and small paper clips*
*Manual Feed
Will not shred: Adhesive labels, CD/DVDs, continuous form paper, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than
noted above
Paper shred size:
Mini-Cut .......................................................................................................4mm x 12mm
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
the instruction manual. Read the entire instruction manual before
operating shredders.
hands away from paper entry. Always set to off or unplug when not
in use.
Reverse (
not place near or over heat source or water.
2
C.
KEY FEATURES AND CONTROLS
G.
H.
B. Auto Feed Access Panel
C. Disconnect Power Switch
1. OFF
D. Manual Feed Slot
E. Pull-Out Bin
F. Casters
Maximum:
90M Sheets per pass (Auto Feed) ................................................................................. 90*
90M Sheets per pass (Manual Feed) ............................................................................... 9*
80M Sheets per pass (Auto Feed) ................................................................................. 80*
80M Sheets per pass (Manual Feed) ............................................................................... 8*
Cards per pass ............................................................................................................... 1*
Paper entry width .................................................................................................. 220mm
* A4 (70g), paper at 220-240V, 50/60 Hz, 1.4Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 600 sheets;
10 credit cards.
move switch to OFF (
immediately.
and easily accessible. Energy converters, transformers, or extension
cords should not be used with this product.
batteries.
ENGLISH
Model 80M/90M
G. See Safety Instructions
H. Control Panel and LEDs
1. Reverse
2. Start (blue)
3. Bin Open
4. Remove Paper (red)
5. Bin Full (red)
6. Overheat (red)