Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
The DC charging output is not regulated. The circuit
breaker does not prevent over charging a battery. Battery
charging should be done in a dry location.
Start generator and turn Economy switch OFF.
1.
Plug Battery Charging Cable into DC V-Outlet, located on
2.
the control panel.
Connect positive (+) battery clamp (red wire) to battery
3.
FIRST.
Connect negative (-) battery clamp (black wire) to battery
4.
SECOND.
This outlet can not recharge 6-volt bat-
NOTICE:
teries and can not be used to crank an
engine having a discharged battery.
Environmental Hazard. Aways recycle
WARNING
batteries at an official recycling center
in accordance with all local laws and regulations. Failure
to do so could result in environmental damage, death or
serious injury. (000228)
Parallel Operation
For output power up to 3400 running Watts, two inverters
can operate in parallel using Parallel Kit (optional). See
the Parallel Kit Operator's Manual or contact Customer
Service at 1-888-431-6871.
All connections to the parallel kit
CAUTION
should be made while both inverters
are turned off and all loads disconnected.
Make sure the Eco Mode Switch is in the same position on
1.
both generators.
Make appropriate parallel connections to the outlets on
2.
each inverter as outlined in the instruction manual supplied
with the kit.
Do not disconnect any parallel kit con-
CAUTION
nections once the units are running.
Start both units per starting instructions. Once the green
3.
output indicator illuminates, devices can be connected and
turned on using the parallel kit outlet.
Generator Shut Down
Follow
4.
For inverters, load applied to the parallel
NOTICE:
kit is not to exceed 4200 starting Watts
due to a 5% power loss when paralleling. See Parallel Kit
Operator's manual.
Only use approved parallel kit.
NOTICE:
14
009611
instructions.
Instruction Manual for Portable Generator
Publicidad
