Publicidad
Idiomas disponibles
Idiomas disponibles
2 Installation
2.1
Installation tips
•
First, turn off all devices (TV and HDMI sources) before connecting them to the
MegaView 67 Pro. If a device cannot be turned off, please remove its plug from
the wall socket.
•
For the best picture and sound quality, only use High Speed HDMI
cables.
2.2
Connecting the transmitter and receiver
In order to check proper functioning of the system, it is advisable to test the set-up first,
using a short CAT5e/6 cable.
1.
Connect the HDMI source to the MegaView 67 Pro transmitter [4], using a High
Speed HDMI
2.
Optional: To continue viewing the HDMI feed in this room as well, use a High
Speed HDMI
OUT"[6] on the transmitter.
3.
Connect the MegaView 67 Pro receiver to the display or projector [9] using a High
Speed HDMI
4.
Use one CAT5e/6 Ethernet cable to connect the MegaView 67 Pro transmitter [2]
to the receiver [8].
Please note: The MegaView 67 Pro cannot be connected to an existing home network
(LAN), this may cause damage to the device.
5.
Use the EDID switch[5] to select which display settings you want to provide to the
source device. Select 'RX' to receive the display information from the display
connected to the receiver. Select 'TX' to receive the display information from the
local display connected to the HDMI output (loop trough) of the transmitter.
6.
Connect the power adapter [3] to the 'DC 12V' connection on the MegaView 67
Pro and plug the adapter into a socket.
Please note: Do not place the MegaView 67 Pro transmitter or receiver in an
enclosed space, such as a TV cabinet or equivalent. Provide adequate ventilation to
ensure that the product is functioning properly and to protect against overheating.
4
transmitter
1
2
4
5
®
certified cable.
®
certified cable to connect a display to the HDMI port marked "HDMI
certified cable.
®
3
7
6
®
certified
receiver
8
9
© MARMITEK
Publicidad
