Hart HPHV50 20V Manual Del Operador página 5

OPERATION
STARTING/STOPPING THE VACUUM
See Figure 2, page 7.
 To start the vacuum: slide the ON/OFF switch toward
the front of the vacuum.
 To stop the vacuum: slide the ON/OFF switch toward
the back of the vacuum.
INSTALLING ACCESSORIES
See Figure 3, page 7.
The following accessories are included:
Item
Crevice Tool ..............................................533070002
Utility Nozzle .............................................536709002
Dust Brush ................................................313281004
2 ft. Extension Hose . .................................315723002
Install only accessories designed for use with this vacuum.
 Turn off the vacuum.
 Remove the battery pack.
MAINTENANCE
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
Part number
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
 P lace the accessory over the port on the nose of the
vacuum.
 Push the accessory securely into place.
 When not in use, remove and store the accessory.
REMOVING/REATTACHING THE DUST BOWL
See Figures 4 - 5, page 7.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
CLEANING/REPLACING THE FILTER
See Figure 6, page 7.
 Remove the battery pack and the dust bowl.
 Remove the filter by pressing the tabs inward and lifting
the filter out of the screen assembly.
 Shake or lightly brush any dust or dirt off the filter.
 Remove the screen assembly from the dust bowl.
 Shake or lightly brush any dust off the screen and screen
assembly. Wash if necessary.
 Empty the dust bowl; wash if necessary. Before
reattaching to the hand vac, make sure all pieces are
completely dry.
When purchasing replacement filter, request recommended
part number 533907002.
5 – English