Publicidad
Idiomas disponibles
Idiomas disponibles
12
11
10
A
A
The installation of a single amplifier requires one rack-mount bracket with short side
mount bracket with long side
of the amplifier and the bracket with the long side to the opposite side. Use the M4 flathead screws for
this.
A
If you want to install two amplifiers side by side in a 19" rack, you will need the two small plates to
connect the amplifiers together at the back
tom
and the two rack-mount brackets with short side
D
back and secure the plates with these screws
M3 countersunk screws to the intended positions on the amplifiers, as shown below. Screw the rack-
mount brackets with the short side
A
9
8
7
B
. Screw the bracket with the short sides to either the left or right side
B
, the two rectangular plates for connection at the bot-
C
. Screw the connecting plates
C
to the sides of the device using the M4 flathead screws.
A
C
C
6
5
B
. Loosen the corresponding screws on the
A
D
WENN NICHT ANDERS DEFINIERT:
BEMASSUNGEN SIND IN MILLIMETER
OBERFLÄCHENBESCHAFFENHEIT:
TOLERANZEN:
LINEAR:
WINKEL:
NAME
GEZEICHNET
GEPRÜFT
GENEHMIGT
PRODUKTION
4
3
2
C
D
and the rack-
A
in with the supplied
A
17
OBERFLÄCHENGÜTE:
ENTGRATEN
ZEICHNUNG NICHT SKALIEREN
UND SCHARFE
KANTEN
BRECHEN
SIGNATUR
DATUM
BENENNUNG:
NOT SPECIFIED
WERKSTOFF:
ZEICHNUNGSNR.
1
ÄNDERUNG
Publicidad
