Descargar Imprimir esta página

POWER SMITH PNLR300M Manual Del Operario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS
Do not place this lithium-ion battery-powered product in
fire or apply heat to it.
Do not apply strong impact or shocks to this lithium-ion
battery-powered product.
Do not allow the lithium-ion battery to get wet.
Do not leave this lithium-ion battery-powered product in
the direct sunlight, or use or store it inside cars in hot
weather. Doing so may cause the battery to generate
heat, rupture, or ignite. Using the battery in this manner
may also result in a loss of performance and a shortened
battery life.
NEVER THROW WATER ON A BURNING LITHIUM-ION
BATTERY! If a lithium-ion battery does catch on fire, it
will burn even more violently when contacted with water.
Store the product at temperatures between 41°F and
77°F (5°C and 25°C).
Properly dispose of all batteries at a recycling center
or per local code. More information regarding battery
disposal in U.S. and Canada is available at; http://www.
rbrc.org/index.html, or by calling 1-800-822-8837
(1-800-8BATTER).
OPERATION
This product comes with one neckband (2-FIG1) and two
rechargeable lights (1-FIG 1).
The included lights can be attached to the neckband by
connecting the magnetic bases (8-FIG1) on the lights to the
neckband. See FIG 1.
CHARGING THE LIGHTS
The two rechargeable lights can be charged at the same
time by using the included dual USB-C charging cable.
1. Make sure the lights are turned off.
2. Lift the rubber cover (6-FIG 1) on each light to access the
charging port (5-FIG 1).
3. Connect the USB end of the charging cable to a standard
5V USB power output.
4. The charging cable has two USB-C ends to charge both
lights at the same time. Connect one to the charging
port on each light.
NOTE: If only one light needs to be charged, just leave
one USB-C end unconnected.
5. The battery power indicator (4-FIG 1) on each light will
be flashing green while charging is in progress.
6. The indicator will turn to solid green when charging is
complete.
SwITCH BuTToN
Each light can operate independently. Press the switch
button (3-FIG 1) to turn the light on. Additional presses cycle
through the light settings in the following sequence.
High - Medium - Low - Off
If the light is left on any power setting for more than 7
seconds, the next press of the switch button will turn the
light off.
BATTERY PowER INDICAToR
Each light has a battery power indicator (4-FIG 1). When
turning on the light, the indicator will illuminate in three
English
different colors. See the Batery Power Indicator Status
Chart for details.
Battery Power Indicator Status Chart
IndIcatoR StatuS
Solid Green
Solid Amber
Solid Red
Flashing Red
uSING THE NECK LIGHT
The lightweight neck light can be worn on the neck and
head. See FIG 2. The light heads swivel up to 70°, allowing
light to be directed where needed.
Each light can be detached from the neckband and
operates independently as a flashlight.
WaRnInG:
unplugged and completely cool before attempting to
clean it.
Your light requires very little care and maintenance. Simply
clean the lens regularly with a non-abrasive cleaner.
This product is warranted free from defects in material
and workmanship for 2 (two) years after date of purchase.
This limited warranty does not cover normal wear and tear
or damage from neglect or accident. The original purchaser
is covered by this warranty and it is not transferable. Prior
to returning your product to store location of purchase,
please call the Toll-Free Help Line for possible solutions.
For questions about this or any other PowerSmith™
product,
Please call Toll-Free:
Or visit our website:
www.
powersmithproducts.com
3
OPERATION
batteRy poweR level
50%-100%
15%-50%
10%-15%
Below 10%. It is time to
charge the light
MAINTENANCE
Always make sure the light is
wARRANTY
HELP LINE
888-552-8665.

Publicidad

loading