Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Locate the Left and Right Door Panels (L & M)
and place them on a soft surface to protect the
finish. Install four Hinges (GG) in the large holes
in the Left and Right Door Panels (L & M). Insert
eight Hinge Screws (HH) through the Hinges
(GG) and into the Left and Right Door Panels (L
& M). Fully tighten the Hinge Screws (HH) with a
screwdriver.
8. Align the door assemblies to the cabinet by
aligning the holes in the Hinges (GG) with the
mantel panels. Attach the door assemblies with
sixteen Hinge Screws (HH). Fully tighten the
Hinge Screws (HH) with a screwdriver. Adjust
the vertical height by loosening the four screws,
"A" in the diagram, on both hinges. Adjust up
or down by a few mm, if needed. Then tighten
the screws again. Adjust the depth by loosening
"B" screw, in the diagram, and adjust the door.
If the door cannot be adjusted, please loosen
screw "C", as shown in the diagram, then try
again. Tighten screws "B" and "C" as shown in
the diagram. Adjust the cabinet doors sideways
by turning the screw "C" on both hinges on
each door. Install the Knobs (FF) to the Left and
Right Door Panels (L & M) with the Bolts (FF) as
shown in the diagram.
9. Locate the Upper Back Panel (N) and the two
Side Back Panels (P) and attach them with
thirty-four Back Panel Screws (EE) as shown
in the diagram. Fully tighten the Back Panel
Screws (EE) with a screwdriver.
7
L
8
FF
A
HH
C
9
P
EE
6
GG
M
B
N
P
HH
Publicidad
