Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling your Wine Cellar
Your wine cellar has 4 leveling legs. After properly
placing your wine cellar in its final position, you can
level your wine cellar.
(Please note that the leg that stands on the hinge is the
shorter leg.)
Leveling legs can be adjusted by turning them
clockwise to raise the wine cellar or by turning them
counterclockwise to lower the cellar.
Installation Limitations
Do not place heavy objects on top of the unit.
Do not locate the unit in a moist place or display in
direct sunlight.
Do not place the unit next to a major appliance that
emits large amounts of heat, such as a dishwasher,
microwave, toaster oven, oven or barbecue, etc.
Do not install your wine cellar in any location not
properly insulated or heated (garage, etc).
Select a suitable location for the wine cellar on a hard,
even surface away from direct sunlight or heat source,
e.g., radiators, baseboard heaters, cooking appliances,
etc. Any surface unevenness should be corrected with
the leveling legs located on the front and rear bottom
corners of the wine cellar. Avoid placing unit where
there may be electrical interference.
NOTE: To minimize the risk of rusting, leakage and
insulation damage, avoid placing the unit in a place
where heavy moisture is present. Under no
circumstances spill or directly apply water onto or
into the unit.
INSTALLING & MAINTAINING
YOUR AIR FILTER
Your Wine Cellar has a removable air filter that helps
keep the fan and motor free of dust and dirt. It is easy
to install and remove, and should be cleaned every 3
months.
To Install:
Align the tabs on the air filter with the slots on the back
of your Wine Cellar. Press the filter down until the filter
retainers attach to the fan cover.
NOTE: This air-intake filter is an accessory to reduce
the chance that the rust and hair from getting into the
ventilation fan and the heat-sink.However, installation of
air filter may slightly affecting the energy performance
of the unit.
To clean:
Remove the air filter and wash with warm, soapy water.
Rinse thoroughly, dry completely, and re-install it in the
back of the Wine Cellar.
WINE CELLAR FEATURES
AND USE
Temperature Adjustments/Control
Important note: In order to operate efficiently,
thermoelectric products should be in an
environment with an ambient temperature of less
than 70°F (21°C).
When initially turned on, the LED will show the default
setting at 55˚F. Your wine cellar has an electronic
temperature control on the front of the unit. You can set
the temperature of your wine cellar at any setting from
39˚ to 68˚F. The LED will then display the set
temperature.
NOTE: White wine temperature is kept at a lower
temperature than red wine.
5
Publicidad
