Publicidad
Idiomas disponibles
Idiomas disponibles
13. Lubrication
The original lubrication of the gun is eliminated through use
and cleaning. In order to guarantee perfect operation, it is
necessary to grease the regulating or fastening threads,
friction areas, etc., on a periodic basis, especially after each
cleaning session and with greater care if the gun has been
cleaned in a machine. Moving parts must be lubricated light-
ly after cleaning has been completed.
We recommend you to use a light SAE 10 oil or natural grea-
se or vasoline.
It is important to check that the lubricant used does not
contain components that might impair the spraying quality
(Silicones, etc.).
14. Health and Safety
In order to carry out maintenance, repairs or cleaning, first disconnect the unit from the power
supply.
Never point the unit towards yourself, others or animals. The thinners and dilution
media used can cause serious injury.
We recommend using this unit in premises with forced ventilation and in accordance with the
current standards and provisions on the matter.
Near the unit, only keep the amount of product and thinner required for the work being done at
that time. After work has been completed, thinners and the product to be applied must be retur-
ned to their corresponding storage location.
Keep the working area clean and free of potentially dangerous waste (thinners, rags, etc...).
While work is in progress, there must not be any source of ignition (naked
flames, lighted cigarettes, etc.) in the working area as these might generate
easily flammable gases. Likewise, the approved protective means must be
used (breathing, hearing, etc.) in accordance with the regulations establi-
shed in this regard.
If the unit is used in an inadequate manner or its components are altered in any way severe
material damage may occur and bodily harm may be caused to the operator, other personnel
and/or animals and may even cause death. SAGOLA S.A.U. accepts no responsibility in for any
damage caused through the incorrect use of the unit.
Always use approved breathing units in accordance with current Standards and Re-
gulations in order to protect yourself from emissions produced during application.
As a general, preventive measure we advise you to wear goggles in accordance with
the specific environmental regulations and characteristics for the work centre.
Wear gloves when handling the product (see the manufacturer's recommendations)
and clean the gun.
If, when the gun is in use, the ambient noise level exceeds 85 dB (A) the use of appro-
ved ear protectors is required.
The unit in itself does not propitiate any mechanical risk of perforations, impact or pinching,
except those deriving from incorrect installations and handling.
ENGLISH
Publicidad
