Publicidad
Idiomas disponibles
Idiomas disponibles
12. SCAN-X
With the SCAN-X module, you can display
the electromagnetic field by means of an
acoustic signal and is therefore suitable
as an effective demonstration for those
interested.
To do this, switch on the Scan Module
by pressing the button, keep it pressed
Changing the battery
and hold it in the area to be tested
of the SCAN-X
(L.E.D. lights up).
The more intensive the signal to be
Open up the SCAN-X Case by
measured, the louder the sound of the
pushing apart the upper and lower
SCAN-X.
case (i.e. by using a screwdriver).
Replace the CR-2032 battery with
It is best to use the program P3:
a new model.
«Energization».
If the battery is low, the red L.E.D. is only
displayed during the first 2 seconds.
Suppose the battery capacity is less than
10%, the red L.E.D. lights up.
Suppose the battery capacity is less than
5%, the red L.E.D. flashes.
21
13. Battery
Do not use the KLOUD
while it is
charging. Both KLOUD
applicators
are
equipped
with
a
high-quality
lithium-ion battery. A fully charged batte-
ry runs for over 4 hours of use or approx.
17 applications of 15 minutes each.
Check battery status
Press the program selection button
for
3 seconds. Depending on the battery
status, the LEDs P1 to P5 light up (example:
Powered by
All LEDs from P1 to P5 light up means
that the battery is full).
100 %
75 %
50 %
25 %
10 %
0 %
The charging time is about 4 hours.
When the battery status is approx.
During the charging process, the charging
20%, the L.E.D. «Low battery» lights up.
L.E.D. «Charging battery» is lit.
Then approx. 2 more therapies can be
performed. At a battery level of approx.
Exception: If the battery is very low, it
10%, this L.E.D. starts flashing. You can
can take one to two minutes to start the
then perform approx. 1 therapy before
device, then the blue power L.E.D. Lights
the battery needs to be recharged.
up, but the system cannot start. in this
case, please connect the charging cable.
As soon as the battery is charged, the
charging process is automatically termin-
The 1.8 m long charging cable and the
ated and the blue charging L.E.D. goes
magnetic connections of the KLOUD
out.
maxi and the KLOUD
convenient
charging.
charging cable to the applicator and
the green L.E.D. on the charging
cable changes to blue. If the L.E.D.
does not change to blue, the battery
is already fully charged. In addition,
the blue charging L.E.D.
applicator keyboard lights up during the
Powered by
charging process.
Powered by
Please switch off the power
after
use to not only save the battery life, but
also to extend the battery life.
If the device is switched on overnight, the
battery will be completely discharged.
«Do not switch off» shortens the battery
life considerably.
Only the original battery and the supplied
detachable power supply unit with the
original charging cable may be used.
If another battery or charging cable is
used, the device can be damaged, e.g.,
mini ensure
the warranty becomes void.
Connect
the
Replacement batteries or charging cables
can be ordered through your CENTROPIX
consultant or online on the CENTROPIX
Partner Page.
This device contains batteries that can
on the
only be replaced by professionals.
22
Publicidad
