KOOMANDO TM 5030 Manual Del Usuario página 3

TM 5030 Control unit
for blinds and awnings
User Manual - Control Panel
I. TECHNICAL SPECIFICATIONS
1 Power supply: 220V AC50Hz
2 Working temperature: -20° +60°
3 Encoding: Rolling code
4 Consumption in stand-by: 2W
5 Motor capacity: 0.5HP (360W), 230V
6 Integrated 10A fuse
7 Operating frequency: 433.92 MHz
8 Memorizable remote controls max: 30
9 Size: 93x57.5x26 mm
10 Weight: 124g
III. CONNECTIONS
Caution: The connection between the motor and the electronic control unit must be direct, pre-existing buttons or control
switches must be eliminated.
L
A. Functionality checks
If possible, position the shutter or the awning halfway down.
Make sure the power is off before connecting the device.
After removing the cover of the control unit, connect the AC220V power supply, the green LED lights up.
Press the ▲ key (up arrow) and check that the shutter/awning opens.
If instead of opening it closes, press the ▀ (STOP) key, disconnect the power supply and invert the terminal cables
▲ UP and ▼ DOWN. The 1/2/3 keys on the transmitter correspond to ▲ ▀ ▼ on the control unit respectively.
B. Deletion of all the memory
Press the S1 key with a pointed object (the red LED lights up) and hold it down for about 8 seconds until the LED returns green.
Release the S1 key: the red LED flashes once and then returns green.
Now the memory has been deleted.
EN
L - N
220V line input
COM ▲ UP e ▼ DOWN
motor outputs
GND
N COM
LED
www.koomando.com - remote control store
II. SAFETY INSTRUCTIONS
-
Please read this manual carefully before operation.
- Ensure that the device is not powered up before opening the
appliance cover.
- Delete the memory before starting the control unit (ref. IV.
Deletion of all the memory).
- The signal can be disturbed by other communication devices.
- The control unit must only be used for the manual control and/or
radio control of gear motors for roller shutters and awnings.
Use for the control of high-risk systems is prohibited.
- All safety risks must be eliminated before use.
- Install in a dry place indoors or in a specific container
SBS DM
LED
Voltage indicator
and memorization
DIP SWITCH
Button
learning S1
DIP1: OFF control 3 keys on the remote
control (1 opens 2 stops 3 closes)
ON control single key.
If you control multiple control units with the
Control buttons
same radio control, set it to ON.
DIP2: ON manually controlled
(when the key is released, the motor stops)
OFF semi-automatic function.
Control Panel
ON
1 2