SPORTSTECH X150 Manual De Usuario página 28

Step 1
Unpack the device and dispose of the plastic
protective wrapping in accordance with the
disposal guidelines.
While holding the device, gently twist the
locking knob counterclockwise to release it
slightly from the main frame to allow the de-
vice to unfold. When it is fully open, tighten the
locking knob.
Step 2
Remove the two pre-installed screws with
washers from the rear stabilizer to the main
frame. Thread the screws with washers through
the main frame and attach them to the rear
stabilizer. Tighten the screws with the Allen key
without using too much force.
Repeat the process for the front stabilizer.
Step 3
Attach the handlebars with the two
(B) screws and washers on the main frame.
Tighten these tightly with the Allen key without
using too much force. Connect the pulse cable
to the pulse connector and the sensor cable
to the sensor connector on the back of the
monitor.
Then slide the monitor onto the bracket in the
middle of the handlebar.
4. ASSEMBLY
Firmly tighten all component parts and pre-assembled parts!
Re-check the tightness before each training session!
28
Locking knob
B