Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustment brightness：
When the light is on: Press and immediately release the Button.
100%
8%
SOS / Rapid Strobe
When the light is off: Press the button hold it down for 3 seconds.
The SOS mode will be on.
Press and immediately release the Button:
SOS
Press the button hold it down for more than 2 seconds.
The SOS mode will be off.
General Maintenance
There two-rings in the tail cap. Use silicone to keep the
O-rings well lubricated. It is important to lubricate the
o-rings if the flashlight has not been used in a long time or
if the o-ring is hard. If the O-ring is damaged, broken or
deformed it should be replaced with the spare.
Note：Do not use a sharp tool to remove the O-rings.
Warning
1.Do not open the tail cap when the video light is in the water.
2.Do not shine the light directly into your eyes or another
person's eyes.
3.Do not touch the battery and charger with wet hands.
4.Use only the manufacturer's battery and charger with this system.
5.If the video light will not be used for a long period of time the
battery should be removed.
Failure to comply with these warning may result in damage
to the video light and will nullify the warranty.
Troubles Shooting
Before returing the video light to the vendor, please try the
following to improve function.
Symptom
Check the battery to make sure
that it is inserted in the correct
The video light
direction
does not work
Check the battery is charged
Check the tail cap is tight
Check the battery to make sure
Indicator light is
that it is inserted into the charger
green when the
in the correct direction and that
battery begins
the battery has good contact with
charging
the charging terminal.
Check the O Rings in the tail
cap to make sure that they are
Internal Leakage
not broken and that there is no
Water
debris which might
www.tdsdive.com
80%
60%
20%
40%
Rapid Strobe
Solution
Thermal protection
When being used at a temperature higher than 50~55°C
and the temperature protection function will be on, and the
brightness change 20%.
When the temperature is lower than 40°C, the temperature
protection function will be off, and the
brightness is restored.
Battery Level Indicator
Blue Light: Battery level is 100% - 80%;
Green Light: Battery level is 80% - 30%;
Red Light: Battery level is 30% - 5%;
Flash red Light: Battery level is < 5%.
Caution: When the battery level indicator is flash red.
1. Unable to switch the mode and adjust the brightness;
2. Only 20% brightness output;
3. Auto shutdown after 10 minutes .
To Charge the battery
1. Insert the plug of the DC charger into the battery (as shown
in the battery installation illustration).
2. Plug the charger into the power outlet. When the battery
starts to charge, the charger's indicator light will turn red.
3. When the battery is fully charged, the indicator light on the
charger will turn green.
4. Be sure to charge the first charge up to 100% capacity.
Warranty
We offer a warranty against manufacturing defects for three
years from the date of purchase. All manufacturing defects
occurring within three years from the date of purchase will be
repaired free of charge. Proof of purchase is required for
warranty support.
The warranty does not cover failures or defects resulting from
misuse (e.g., modifications or damage), natural disasters,
problems with the charger or battery, including improper
battery installation.
UPDATE INSTRUCTIONS QR CODE SCAN
www.tdsdive.com
Publicidad
