Descargar Imprimir esta página

CGOLDENWALL Upright Serie Manual Del Usuario página 22

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

 Troubleshooting
Trouble
1. The machine does
not start after power
on
2. Motor run slowly,
or not runs, even
vibrates, making
noise
3. Motor cabin over
heat
4. Spark on the
carbon brush surface
Cause
1. Poor contact between the
plug and socket
2. The induction switch in the
two buckles of the cover is not
triggered
3. Air over-load protector
protecting
4. Carbon brush ware out
1. The blade is stuck inside of
the grinding bin by material, or
other foreign subject
2. Low power voltage
1. Over load capacity
2. The grinding material is wet
or the motor gets damp
3. Low power voltage
1. Carbon brush's surface is not
smooth
(*Please cut off the power
1. Repair or replace a new
power plug or socket
2. Adjust the screws on the
two sides and rotate the lid to
the end and locked tightly on
the top.
3. Press the air over-load
protector to restart
4. Change the carbon brush
1. Clean the blade and remove
the stuck stuff, run idling for
10 seconds
2. Adjust the power voltage
1. Reducing the amount of
grinding and decreasing the
working pressure
2. Dry the material before use
and dry the motor
3. Adjust the power voltage
1. Remove the stuff on the
carbon brush's surface
17
Elimination method
when doing following)

Publicidad

loading