Anti-Kickbacks Pawls And Blade Guard - Delta 36-6013 Manual De Instrucciones

ANTI-KICKBACK PAWLS AND BLADE GUARD
ANTI-KICKBACK PAWLS
To reduce the risk of serious personal injury,
anti-kickback pawls must be in place when
making a through cut.
1.
Refer to Figure 9 and locate the anti-kickback pawls mounting slot in the middle of the top edge of the riving knife.
2.
Slide slot in the middle of the anti-kickback pawls assembly along the top of the riving knife until the stem locates the center
slot on the riving knife.
3.
Depress the stem on the anti-kickback pawls assembly to allow the assembly to drop into the slot. Push down on the anti-
kickback pawls assembly until it snaps into place and locks. Release stem. NOTE: Pull up on the anti-kickback pawls to make
sure it is locked in place.
If blade guard is not parallel to table, riving knife is not in raised (through cut) position. Raise and lower each side of the blade
guard to verify free movement of the guard system. Be sure the guard system can be raised enough to clear your workpiece.
Note: Blade alignment with riving knife can be adjusted. See: Checking and Aligning Riving Knife and Saw Blade, page 33.
Check the blade guard for clearances and free movement.
ASSEMBLY
PRESS
PIN
FIGURE 9
FIGURE 9B
15
N
RIVING
KNIFE
To remove the anti-kickback pawls, depress the stem and pull
the anti-kickback assembly off the riving knife.