Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
•
Ensure that the rated working pressure of each pressurized attachment be equal to or greater
than the rated working pressure developed by the hydraulic pump.
•
Always check connections before using. Alteration of these products is strictly prohibited. Use
only those adapters and attachments provided and approved by the manufacturer.
•
When extension tubes and/or offset attachments are used, the rated capacity is always reduced
by 50% for each tube or offset attachment connected.
•
Do not attempt to operate pump unless the Breather Valve is open.
•
Do not overextend the Ram. (Do not over the Warning Line on the Piston of Ram.)
•
Do not exceed rated capacity.
SETUP
All numbers in the text below are listed and sketched in the chapter "DIAGRAM" below.
RAM ATTACHMENTS
•
The Extensions (2a - 2e) connect in different combinations to reach desired lengths.
•
The Male Connector(B) is used to connect the female end of the Ram (B) to a Base.
•
The Fiat Base (3) is typically used on the stationary side to spread out the force of the Ram (B).
•
The 90° V Head (7) is used to offset the force of the Ram (B) when there is not a straight line
between the stationary side and the damaged side, or to spread out force on curved surfaces.
•
The Gap Head (9) is typically used on the pushing end to prevent slipping.
•
The Rubber Head (10) is typically used for popping dents out of sheet metal such as doors or
body panels and to minimize damage to the work surface.
•
The Wedge Head (6) is used to repair small dents and areas located in angles and tight spaces.
•
The Flange Base and Flange Head (4, 5) are used together to allow spreading in areas that the
Ram cannot fit into.
•
Note: The Flange Base and Flange Head must only be used together to prevent an off-center
load.
SPREADER SETUP
The Spreader (C) is used when the Ram (B) is too long to fit between the stationary side and the
damaged area.
1. Clean the end of the Hose (21) and the inlet on the Spreader (C).
2. Unscrew and save the Dust Covers located on the end of the Hose (21) and Spreader (C).
3. Attach the Hose (21) to the Spreader Wedge (C), as shown below:
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
