Weller WLSK3023 Traducción Del Manual Original página 10

ENGLISH
GB
Read these instructions and the safety
guidelines carefully before starting up the unit
and starting work.
Failure to observe the safety regulations results in a risk to
life and limb.
Keep these instructions in a place that is accessible to all
users. Please adhere to the operating instructions of the
connected devices.
Safety information
This appliance can be used by child-
ren aged from 8 years and above and
persons with reduced physical, sensory
or mental capabilities or lack of experi-
ence and knowledge if they have been
given supervision or instruction concer-
ning use of the appliance in a safe way
and understand the hazards involved.
Children shall not play with the appli-
ance.
Cleaning and user maintenance shall
not be made by children without super-
vision.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
Specified Conditions Of Use
Use the soldering station only for the purpose of soldering,
as specified in the Operating Instructions.
This device may only be used at room temperature and
indoors. Protect against moisture and direct sunlight.
WARNING Electrical shock
Connecting the control unit incorrectly poses a risk of
injury due to electric shock and can damage the device.
Carefully read the attached safety information, the safety
•
information accompanying these operating instructions as
well as the operating instructions for your control unit
before putting the control unit into operation and observe
the safety precautions specified therein.
Only connect WELLER tools.
•
10
If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Repairs must always be referred to a Weller-trained
•
specialist.
If the electrical tool's power supply cord is damaged, it
•
must be replaced with a specially prefabricated power
supply cord available through the customer service
organisation.
Avoid touching earthed objects such as pipes, heaters,
•
stoves and refrigerators.
Do not use the soldering tool in a damp or wet environ-
•
ment.
Never work on voltage-carrying parts.
•
WARNING Risk of burns
Risk of burns from the soldering tool while the control
unit is operating. Tools may still be hot long after they
have been switched off.
Always place the soldering tool in the safety rest while not
•
in use. Make sure the safety holder is stable.
Only replace solder tips when cold
•
Risk of burning through liquid solder.
Protect yourself against solder splashes.
Wear appropriate protective clothing to protect yourself
•
against burns. Protect your eyes by wearing eye
protection.
When working with adhesives, special attention must be
•
paid to the warning information provided by the adhesive
manufacturer.
WARNING Fire hazard
Covering the soldering iron or the safety holder poses
a fire hazard. Always keep objects well away from the
soldering iron and safety holder.
Always keep objects well away from the soldering iron and
•
safety holder.
Keep all combustible objects, liquids or gases well away
•
from the hot soldering tool.
Store your soldering tool in a safe place. When not in use,
units and tools should be stored in a dry, high or locked area
out of the reach of children. Make sure that unused soldering
tools are free of voltage and de-pressurised.
The power cable must only be plugged into the power
socket or adapter approved for this purpose. Check
to see if the mains voltage matches the ratings on the
nameplate. Make sure the machine is switched off before
plugging in.
Do not use the cable for purposes other than those for
which it is intended. Never carry the unit by the cable. Do
not use the cable to pull the plug out of the socket. Protect
the cable against heat, oil and sharp edges.