Noaton FORNAX Manual De Instrucciones página 28

6 INSTALLATION PROCEDURE
1. Disconnect the relevant wires from the power supply.
2. Secure the mounting plate
- First, remove the parts bag from the package; there are two different types of screws in
the package to secure the mounting plate, one for concrete ceiling and the other for
wooden ceiling - select the correct screws to secure the ceiling fan.
- When installing, the power wires should pass through the middle round hole.
2x Anchor 4x Screw for
for concrete
wooden
ceiling ceiling
TIPS: When using different screws to secure the mounting plate to a different type of ceiling, please
do not install the mounting plate on a type of ceiling that is unable to support the weight of about
60kg, to prevent potential danger. After securing the mounting plate, make sure the ceiling is able
to support 60 kg.
6.1 INSTALLATION OF THE MOTOR AND FAN RECEIVER
WARNING:
For your safety, make sure the power is turned off.
1. As shown, unscrew the four mounting screws on the mounting plate, then remove the motor
from the package.
2. Insert the steel motor cable latch into the mounting plate hook. Use the screws to attach the
the motor to the mounting plate.
3. Connect the power wires to the terminal block on the motor bracket.
4. Remove the receiver from the package and insert it into the space between the mounting plate
and the motor bracket.
5. Connect the appropriate connectors to each other (1 connector on the receiver input, 2
connectors on the receiver output, 1 ground cable connector).
Installation for wooden ceiling.
Before installing on wood, make sure
the ceiling can support a minimum of
60 kg. The mounting plate should be
installed on a stable part of the ceiling.
Screw the mounting plate to the
wooden ceiling using 4 screws.
28
Installation for concrete ceiling
First drill 2 holes with an impact drill
(8 mm drill bit), the length of which
corresponds to the length of the
anchor, and then attach the
mounting plate using two anchors.
The correct 2 holes on the mounting
plate are located closer to the
screws (complications may occur
when inserting the receiver).
Hook
Steel
cable
Hanging
bracket
Screws
EN