KIDdesigns Tech2Go PW-V302 Manual Del Usuario

ADVENTURE KIT
Included:
Flashlight
ON/OFF Switch
This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE).
This means that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on
the environment.
For further information, please contact your local or regional authorities.
Electronic products not included in the selective sorting process are potentially dangerous for the environment and human health due to the presence of
hazardous substances.
The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the RED Directive 2014/53/EU.
We,Tech2Go, declare that this device complies with the essential requirements of the RED Directive 2014/53/EU
Installing the Batteries
Flashlight
ATTENTION: Batteries should only be installed by
an adult. BATTERIES NOT INCLUDED
1. Use a Philips screwdriver to open the battery
compartment door located on the back of the
unit.
2. Install 1 " AA" size battery into the
compartment, making sure that the + and -
polarities match the diagram printed inside.
3. Close the battery compartment door and
tighten the battery door screw. Don't over
tighten.
Battery Use Cautions and Tips for Safety & Best Performance
• Only use the recommended/supplied batteries or equivalent.
• Rechargeable batteries are to be removed from the toy before being charged.
• The supply terminals are not to be short-circuited.
• Use alkaline batteries for longer life.
• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc or rechargeable nickel-cadmium batteries.
• Insert batteries with proper polarity (+/–) as indicated.
• Remove exhausted batteries from product.
• Recharge rechargeable batteries under adult supervision.
• Do not attempt to recharge non-rechargeable batteries.
• Do not open batteries or heat them beyond normal ambient temperatures.
• To prevent battery leakage or damage remove batteries from a product if it will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY flush the
eye with lukewarm and gently flowing water for at least 30 minutes. If skin contact occurs, wash skin with clear water for at least 15 minutes. Seek medical attention
if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or combustible material.
• Do not dispose of batteries in the household trash or fire.
• Follow applicable laws and local regulations for the disposal and transportation of batteries.
• Do not dispose of batteries in fire; batteries may leak or explode.
• Batteries should be replaced by an adult.
• Remove all packaging before giving to your child.
Maintenance
• It is important to keep the unit as dry and clean as possible. You may clean the cabinet with a cloth or sponge moistened with mild soap and water. Do not attempt
to use strong cleansers or solvents, as they may cause damage.
Binocular
Compass
Battery Installation
Walkie Talkies
Talk Button
ON/OFF Switch
Speaker/Microphone
Walkie Talkies
ATTENTION: Batteries should only be installed by
an adult. To install the batteries at home:
1. Open the battery compartment door.
2. Install one "9V" size battery into the
compartment of each Walkie Talkie, making
sure that the + and - polarities match the
diagram printed inside.
3. Close the battery compartment door.
ENG
Model: PW-V302
Headphones
Battery Installation