Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Before first use
•
Before using the product for the first time, make sure it is switched off and disconnected
from the power supply.
•
Clean the product's exterior with a soft, damp cloth, then dry it thoroughly.
•
Do not immerse the product in water or any other liquid.
•
Remove the tank from its housing. Fill your tank via the water filler to its maximum level
(1.8 L), then reposition the tank.
•
Unlock your iron by sliding the iron release button to the left, towards the
•
Place your steam station on a flat, stable surface. Plug the cable into an electrical socket.
•
Press the power button on the control panel once. The unit will then beep, and the operation
indicator light will light up to indicate that the unit is on.
Note: The low steam indicator light will turn on because the low steam level is
pre-programmed for when the unit starts up.
•
Press the steam level selection button twice to select the maximum level. The maximum
steam indicator will light up.
•
Turn the thermostat knob to the MAX position.
The iron preheating indicator light will turn on to indicate that the iron is heating up.
Repeatedly press the steam control button to start the steam function, then iron over a
tea towel for 10 minutes to remove any residue inside or on the soleplate.
Note: Steam is emitted in less than 15 seconds to indicate that the unit is ready.
Note: Odours and particles may be emitted from the unit during its first few uses.
This is normal and will quickly stop. When you turn on your steam station, a pumping
sound will be heard emanating from the unit. This is normal and indicates that
water is being pumped through the system. During the iron's preheating phase,
water may drip from the unit. This will only last a few seconds.
Use
Filling the tank
Remove the water tank from its housing by grasping its handle.
18
EN
symbol.
Publicidad
