Casselin CRLCT Manual De Instrucciones página 16

USE
1. Operating instructions
1.1 Turn on the system, switch the external power to "I", and the unit starts working and displaying the current
refrigeration temperature.
1.2 Turning the external power to "O", the display panel turns off.
2 Refrigeration temperature value setting
(if the following button is valid, the beep will sound and a click will be emitted)
2.1 In working condition, display the temperature inside the refrigerator. Press on " "to enter the
temperature setting state, and the temperature setting value flashes, press the button " " "Where "
again, the temperature setting value increases by 1 or decreases by 1, long press " " Where "
enter the button acceleration state after 1 second, set the value every 0.3 seconds increase by 1 or
decrease by 1.
2.2 Temperature setting range: 1°C~6°C, default value: 2°C, STEP=1°C.
2.3 In temperature setting mode, if you do not press any button for more than 5 seconds, you will exit
temperature setting mode and return to normal display. The settings are saved.
3.LED lamp on and off operation
3.1 When the machine is normally started and the lamp is on, press the button
" " and the LED lamp turns off; click again and the LED lamp turns on (the state of the LED lamp is saved.
3.2 If you are in the temperature setting state, press the "
4 Heating Instructions
4.1 When the system is running, the default heating temperature is set to 60°C; when the heating
temperature = 60°C, the heating output is closed; when the temperature is <58°C, the heating is
activated.
4.2 The heating temperature is the fixed value of the system and cannot be adjusted.
4.3 If the heater temperature sensor is abnormal, the error code displays "E1", and the heater stops working.
5 Refrigeration Temperature Control Instructions
5.1 In the normal start state, when the current temperature is higher than the set temperature + the return
difference value, the compressor starts to work (The compressor should be started with a delay of 3 minutes).
5.2 Current temperature? the set temperature, the compressor stops.
5.3 Return difference: 2°C
5.4 If the refrigeration temperature sensor is abnormal, the error code will display "E0". At this time, the
compressor will work in "on" mode for 45MIN, stop for 15MIN until the temperature sensor returns to normal
display.
Coded
E0 Refrigerator temperature sensor short or open circuit.
E1 Short circuit or open circuit of the heating temperature sensor
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
WARNING
Never place dishes directly on the shelves.
When the cup warmer is on, some parts of the appliance become hot.
To avoid any risk of burns, do not touch hot surfaces with bare hands, wear protective gloves.
" to adjust the temperature set value down.
Description
EN
"
", and