AEG AWUS018B7B Manual De Instrucciones página 67

9.1 What to do if...
Problem
The appliance does not op‐
erate.
The compressor operates
continually.
The light does not work.
Too much vibration.
The appliance is noisy.
Water flows on the rear plate
of the appliance.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The circuit breaker tripped
or a blown fuse.
Temperature is set incor‐
rectly.
The room temperature is
too high.
The door is opened too of‐
ten.
The door is not closed cor‐
rectly.
The light is turned off.
The appliance is not plug‐
ged in.
The circuit breaker tripped
or a blown fuse.
The lamp is defective.
The light button is not op‐
erating.
The appliance is not sup‐
ported properly.
The appliance is not sup‐
ported properly.
During the automatic de‐
frosting process, frost
melts on the rear plate.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket,
to check if electricity is flowing.
If not, contact a qualified elec‐
trician.
Turn on the circuit breaker or
change the fuse.
Refer to the "Operation" chap‐
ter.
Refer to the "Installation"
chapter.
Do not keep the door open
longer than necessary.
Refer to the "Closing the door"
section.
Turn on the light. Refer to the
"Light setup" section.
Connect the appliance.
Turn on the circuit breaker or
change the fuse.
Contact the Authorised Serv‐
ice Centre.
Contact the Authorised Serv‐
ice Centre.
Check if the appliance stands
stable.
Check if the appliance stands
stable.
This is correct.
67