IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Read all instructions before using.
DANGER
- To reduce the risk of electric shock:
Once installed, do not remove the mirror from the wall without first turning the power o from the electrical panel.
WARNING
- To reduce the risk of burns, fire, injury, or death from electric shock:
1. Close supervision is necessary when this furnishing is used by, or near children, invalids, or disabled persons.
2. Use this furnishing only for its intended use as described in these instructions. Do not use attachments not recommended
by the manufacturer.
3. Never operate this furnishing if it is not working properly, if it has been dropped or damaged, or dropped into water.
Return the furnishing to a service center for examination and repair.
4. Never drop or insert any object into any opening.
5. Do not use outdoors.
6. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
7. To disconnect, turn all controls to the o position and turn the power o from the electrical panel.
WARNING
8.
: Risk of injury or death from electric shock - Connect this furnishing to a properly grounded outlet only.
See Grounding Instructions.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
This product must be connected to a grounded metal, permanent wiring system, or an equipment-grounding conductor must
be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the product.
THANK YOU
We can assure you that we have used the best materials and have applied the strictest quality control measures to ensure
that each and every unit meets the highest quality standards. This booklet contains general information about the unit as well
as step-by-step installation instructions.
BEFORE BEGINNING
• Carefully read the instructions before beginning the installation.
• DANGER! To avoid the risk of electrocution, please turn o the electrical panel before starting the installation.
• It is strongly recommended that this installation be performed by a licensed professional electrician.
• It is recommended that you wear safety glasses at all times during the installation.
• A minimum of two people are needed to perform this installation.
• This product is wall mounted only.
MAINTENANCE
Never use scouring powder pads, abrasive material, strong bleach or sharp instruments on metal components or glass. An
occasional wiping down with a mild soap diluted in water is all that is needed to keep the mirror and aluminum parts looking
new. Test products on a small inconspicuous surface prior to use.
2