Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Unpack and carefully check that there is no transportation damage before using the
unit. Keep the equipment packaging. To fully protect the device against vibration, dust
and moisture during transportation or storage use the original packaging or your own
packaging material suitable for transport or storage, respectively.
The device should be located on a secure, solid surface such as the floor. The machine
can operate in any orientation from 45 degrees upwards to 45 degrees downwards.
Take precautions to avoid Liquid spills if the machine is oriented at an angle.
Do not connect the unit to the mains before checking the mains voltage and
before all other connections have been made.
2. Precautions/ safety warnings
The LFM-110 was developed for private use only, disco party etc.
-
The LFM-110 is only approved for a mains connection up to 230 VAC 50/60 Hz
-
Regular breaks during operation will increase the lifetime of the LFM-110.
-
Take care that no cables are lying around. You would endanger your own safety
-
and also the safety of a third party.
Keep the LFM-110 dry and keep it away from water or high humidity. It could
-
reduce the isolation of the device and cause short circuit and/or electric
shocks.
When using the LFM-110 fog machine you have to ensure that there is still a good
-
visibility of at least 10m.
Don't operate the device during thunderstorms. Surge voltages can damage the
-
device. Unplug the LFM-110 from the power supply during thunderstorms.
Keep Surrounding objects at a safe distance of >1m
-
Keep the device away from children and never operate it unattended.
-
Never aim the nozzle directly on people; the ejected fog is very hot!
-
Never use flammable substances, oil, gas, perfumes, etc. in your fog fluid.
-
Never aim the nozzle on open fire or flammable objects.
-
Make sure to fill the LFM-110 with fog fluid in time. If the machine is operated
-
without fluid it can cause damage to the pump or the heating block.
When removing the Fog fluid, first unplug the device from the power supply.
-
Never drink the fog fluid. If this does happen, please contact a doctor. If the fluid
-
came in contact with the eyes, immediately rinse with a lot of water.
Fog Operating
Filling the unit
!
NOTICE!
Possible damages caused by unsuitable fog liquid. We advise to use Lenco FOG
liquid FML-100 or similar.
Warning: don't use Oil based Haze fluids. These will damage the LFM-110
First, make sure the unit is disconnected from the mains
Open the screw-cap of the liquid tank and fill in the fog Liquid. Make sure that no fog
Liquid is spilled or gets into the device. The easiest way is using a funnel. The tank
capacity is 1.0 litre. Make sure the little filter of the tank hose is immersed into the smoke
fluid. Firmly screw the cap back onto the tank
7
OPERATING
Publicidad
