Audibax Rock 6T Manual Del Usuario página 2

Rock 6T
Packing List
speaker
Introduction
Thank you for buying outdoor speaker. Please read and have a thorough understan-
ding of the entire manual before installation and use. Keep the manual for
maintenance.
Important
Audibax has made ever y effort to provide accurate and detailed instr uction for this
product's assembly and installation. Should you have any doubts consult a qualified
professional fitter, Audibax recognizes no liability for any difficulty or problem derived
from the interpretation of these instr uctions. These brackets and all their parts and
accessories must only be used for the purpose they have been constructed.
Audibax , its commercial distributors and retailers are not , directly or indirectly,
responsible for any damage to persons and or properties derived from the use of this
product in an unsafe or different way for which it has been designed and constr
ucted. Several parts of this product are small pieces of hardware therefore extreme
care should be taken to keep them from children.
Read These Instructions Carefully Before Using the Product
1. When the speakers are installed outdoor, check that the wall str ucture is reliable
and that the speaker is fir mly attached. The user should be responsible for this very
thing.
2. Do not place the speakers on a turntable or movable support.
3. Do not touch or bump the woofer and tweeter. If these are damaged, the sound
will be distorted.
4. Do not listen to sound at a ver y high level when you are changing the input source
(for example, to tune FM / CD) installation or removal of cables should make sure
that the power amp / amplifier device radio is tur ned off.
5. Don't attempt to clean the speakers with chemical solvents as this may damage
the paint surface. Clean with a dr y cloth.
Direct Burial Wire or Conduit
Depending on the type of installation, direct burial of the speaker wires from the
amplifier to the loudspeakers may be adequate, or the use of 12 ID conduit may be
required for protecting the wires from possible physical damage if future excavation
or other alterations are anticipated in the area of the installation.
1
Connections/wiring
user manual
Specifications
Model
Frequency Resp(-10dB)(Hz)
Sensitivity(1W/1M)(dB)
Impedance
RMS power(watts)
Peak power(watts)
Fixed Transformer
Enclosure material
IP Rating
NOTE:
-Soder wires together using waterproof heat shrink tubing to seal.
-Use waterproof wire connectors.
-Make connections with immersion-resistant crimp splices.
-Use grease wire caps.
Connection
Use wire on the back of the speaker in the output tab of the amplifier (or amplifiers of
radio). The speaker wire is on one side red and on the other one black. Connect to
the red side of the amplifier and speakers (+) tab. Connect one end of the black side
(-) in the other tab. Connect each speaker to make sure that is not (+,-) inverted
polarity. If the polarity of the speakers is reversed, the sound will be unnatural and will
play without bass.
Underpowering Vs. Overpowering
-Most speaker damage is caused by amplifiers with too little power (wattage).
-An overdriven amplifier clips the waveforms and sends distortion to the speakers.
-Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear
sound.
BLUE(COMMON)
YELLOW/GREEN
------30 WATTS 70V
BROWN
------30 WATTS 100V
Rock 6T
75-20K
87
70V / 100V
40
80
70V: 30W
100V: 30W
LLDPE
IP56
USER´S
MANUAL
2