Hama 00176578 Instrucciones De Uso página 6

Warning
• Please note that lights (even LEDs) can
generate heat and may become hot. Always
let the light cool down for a few minutes
before touching it.
• The device can only be operated on a 230
V / 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certi ed in your country. The
applicable accident prevention regulations
must be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch
off the automatic circuit breaker). Failure to
comply with the installation instructions can
cause res or other hazards.
Risk of electric shock
Do not open the product and do not operate
it if it is damaged, if smoke, a strange smell or
loud noises are coming from it. Immediately
contact your dealer or our service department
(see item "Service and Support").
Note
The light source of this light is not replaceable;
when the light source has reached the end of
its life, you need to replace the entire light.
6
Warning
Never look straight into the light source and do
not aim its beam of light straight into the eyes
of other people or animals. This could damage
your/their eyes.
Example installation in wood / drywall
ceiling:
1. Before commencing any installation,
maintenance or repair work, please
disconnect the power circuit by
disconnecting the fuse.
2. Secure the power circuit against being
switched back on.
3. Check that the minimum installation depth
of 80 mm (47 mm light + 33 mm clearance)
is available. The clearance between the
upper edge of the light and the ceiling must
not be less than 33 mm to allow ventilation.
The minimum distance between the lights
and ammable materials must be no less
than 50 cm. Do not cover the light with any
heat-insulating material.
4. Mark out the position where the light is to
be installed.
5. Create an installation opening with a
diameter of 75 mm using a suitable hole
saw. Take care not to disturb any hidden
installation or supply lines.
6. The terminal points (e.g. terminal strip)
between the domestic installation and the
built-in spotlight connection cable must be
clamped in suitable junction boxes. (Not