Publicidad
Idiomas disponibles
Idiomas disponibles
If you want to use one of the floor suction accessories:
1. Insert the handle/adaptor (12) into the suction tube (13);
For the other suction accessories:
2. Insert the handle/adaptor (12) of the suction accessories
into the fitting nozzle.
Do not run the vacuum cleaner for more than 4 hours,
including rest breaks. Make sure the vacuum cleaner is
regularly switched off to allow the motor to cool down
(every 15 min switch off for 1 min). Otherwise, you may
damage the motor.
Never use the appliance for vacuuming:
•
Hazardous dust to health;
•
Hot or burning materials such as cigarettes, matches or
hot ashes;
•
Flammable or combustible liquids, such as petrol,
solvents, acids or bleach;
•
Combustible or explosive dusts, e.g. magnesium dust;
•
Sharp objects.
Never use the vacuum cleaner if the suction power is too
low. If this happens, check that the filter bag is full and
check the condition of the filters (refer to maintenance
instructions). Also check if there are any blockages or
clogging in the hose, tube or suction accessories.
Avoid vacuuming up debris and materials that could reduce
airflow and block or clog accessories.
Do not use the cleaner if it does not operate normally. If the
problem persists, have the vacuum cleaner serviced by the
brand technical assistance.
1. Unwind the power cord (18) and plug it into the socket;
2. Fit the vacuuming accessory according to the waste to
be vacuumed;
3. Set one of the "ON/OFF" push-buttons to position (I) (10).
If the suction power is not sufficient, set the other
"ON/OFF" button to position (I) to increase the suction
power and airflow. Do not turn on both buttons at the
same time.
To switch off the vacuuming cleaner:
4. Set the "ON/OFF" buttons to the (O) position and unplug
the power cord. Always switch off the vacuum cleaner
before unplugging the power cord;
5. Wind the power cord.
1. Fit the dust and solids floor nozzle (17) and adjust its
brush position according to the type of floor to be
vacuumed;
•
For carpets and wood floors press the button
downwards.
•
For ceramic floors pull the button up.
2. Keep the filter bag in place inside the vacuum cleaner.
1. Fit the floor nozzle for liquids;
2. Undo the fastening latches (6) and remove the vacuum
cleaner head (7);
3. Remove the filter bag from inside the vacuum cleaner;
the filter bag;
4. Refit the vacuum cleaner head and switch it on again.
Always remove the filter bag when vacuuming liquids.
Publicidad
