Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Symptom
Machine turns on but
it does not draw any
water or there is not
sufficient pressure.
Multi-spray nozzle
leaks.
Outlet pressure
increases suddenly.
Machine drains out water
after stopping.
Soap accessory
cannot spray out any
detergent.
Machine does not start.
Machine pressure is not
consistent.
Machine stops
automatically.
Machine does not draw
any water after long
time storage.
Cordless Portable Power Cleaner
Possible causes
Power nozzle is too high from the
water source surface.
The users garden hose is not well
connected to the machine.
The pump filter screen is blocked.
(See Fig. X1, X2)
Pump, hose, or other parts are frozen
due to outside temperatures.
Hose kinks.
Additional air could be sucked into
the machine.
The nozzle pattern does not spray
correctly.
Fixing nail of the multi-spray nozzle
loosens.
Air built up within the hose or pump.
Multi-spray nozzle is blocked.
There is water remaining in the lance
and pump after stopping.
Blockage in the soap bottle.
The machine is not connected to
the water source.
The battery pack is not attached well.
Battery pack is empty.
Defective battery.
Additional air could be sucked
into the machine.
It is at low pressure setting.
Battery pack is empty.
The multi-spray nozzle is blocked.
The current protection is activated.
Additional air could be sucked into
the machine.
Solution
Lower the machine below 5ft/1.5m.
Check and reattach the garden hose tightly. (See Fig. H2)
Clean the filter screen regularly.
Wait for the pump, hose or other parts to thaw.
Straighten out the hose.
If air builds up within the hose or pump, the water
pressure will drop. First, restart the machine, then
air will be released through the multi-spray nozzle
along with water.
Make sure the nozzle pattern symbol aligns with the
indicator mark on tool.
Tighten it with a hex key.
Continue to operate the machine for a few moments
until leakage stops.
Replace with a new multi-spray nozzle.
Drain all the water completely before storage.
Clean it with fresh water.
Connect to the water source before turning on the
machine.
Reinstall the battery pack.
Replace with a new battery pack or recharge the battery
pack.
Replace with a new battery pack.
Check connection between the hose adapter and
the draw hose.
No action need.
Replace with a new battery pack or recharge the
battery pack.
Remove the multi-spray nozzle and turn on the
machine. If the machine works normally, replace with a
new multi-spray nozzle.
Connect the machine to the water source and then turns
it on.
17
EN
Publicidad
