JANE 50325 Manual De Instrucciones página 4

EN
Collapsible bed rail, detachable
IMPORTANT: KEEP FOR FUTURE REFERENCE.
Read the entire instruction before assembling and installing this product.
If you sell or give away this product, make sure you give this instruction to the new owner.
Make sure that no parts are missing before fitting the rail (see parts list).
This bed rail complies with BS 7972:2001+A1:2009 - Made in China - Designed in Spain.
WARNING
1-The bedguard should not be used for children under the age of 18 months or when the child is over the age of 5 years. This
bed rail is used only when the child is able to climb in and out of bed unaided.
2-The bedguard should not be used as a substitute for a a cot, as it cannot provide the same level of safety as a cot.
3-Suitable for use with beds of the following sizes: minimum 80x190 cm and maximum: 150x200 cm. and mattress with a
thickness of between 15 to 30 cm.
4-Once installed, make sure the bed rail is correctly fitted and is secure.
5-The bedguard should not be used on a sleeping surface that is more than 600 mm from the floor. Never use on a bunk bed,
a child's bed or any other bed hat does not correspond to the present instructions.
6-To avoid risk of injury, carefully respect the present instructions when assembling, installing and using this bed rail.
7-Do not leave the child unattended while fitting or dismantling this product; the child should always be under an adult's supervision.
8-It should be checked periodically that the bed rail is always properly fitted and secure in place, and the locking mechanism on
the bedrail are securely fixed. The bedguard should be periodically checked for its general condition with particular reference
to the security of any locking mechanism and/or hinges that are used on the product.
9-Keep away from fire.
10-Do not use accessories that have not been approved by JANÉ. Additional and replacement parts should be obtained only from
the manufacturer.
11-The bedguard should not be used unless the fixings are in place and securely attached to both the bed and/or the mattress
and the bedguard.
12-This bed rail is suitable for all types of bed bases.
ASSEMBLY PARTS
A TOP BAR
B RAIL FABRIC COVER
C HINGED SIDE BARS
D BOTTOM BAR
E STABILISER FEET
F TRAVEL BAG
ASSEMBLY
The images shown in the step-by-step assembly instructions may differ from the model purchased in terms of colour design. Make sure that you have all the parts
shown in the box above before starting to assemble the bed rail. Steps to follow:
1) Assemble or join the top bar A.
2) Pass one of the ends of the bar that you have just joined (in the form of a bridge) through the fabric cover. Take care when fitting the fabric cover and make sure
that the JANÉ logo is on the outside.
3) Join each of the hinged side bars C containing the collapsible mechanism to each end of the top bar and finish putting the fabric cover on.
4) Join the two parts that make up the bottom bar D.
5) Insert the bar through the bottom part of the fabric cover.
6) Join the bar to the hinged side bars by fitting the connection pins.
7) Place the two stabiliser feet E on each hinged side bar, fitting the connection pins.
8) Place the bed rail on the floor and fold down each of the hinged joints that form each side angle.
1
4
6
4
2
5
7
3
8