SUHNER ABRASIVE LSB 90-TOP Documentación Técnica página 16

1. n
1.1 g
enerAl notes on sAfety
This operation manual is applicable for the machine LSB
90-TOP.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the mAchine for PurPoses for
which it is intended
The tool is designed for grinding, milling, and deburring
metal, stone, and plastic with milling cutters and grinding
attachments.
1.3 i
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 ec
declArAtion of conformity
Otto Suhner GmbH of Trottäcker 50, D-79713 Bad Säck-
ingen, hereby declares under sole responsibility that the
product with the serial or batch no. (see reverse side)
complies with the requirements under the Directive
2006/42/EG. Applied standards: EN ISO 12100, EN ISO
11148. Document Agent: M. Voyame. D-Bad Säckingen,
03/2018. M. Voyame/Managing Division manager
2. c
2.1 P
rior to tAKing the mAchine into serVice
Oiled compressed air is recommended (see also
air quality under section 2.3).
Observe national regulations.
2.2 t
AKing the mAchine into serVice
Before connecting the tool to the com-
pressed air supply set the rotary valve to
the «OFF» position!
The tool may be switched on only when the lock and at-
tachment have been installed correctly.
16
S
oteS on afety
ommISSIonIng
2.2.1 t /t
urn on urn off
Switch the tool on by turning in the direction of the arrow
to "I". Switch the tool off by turning in the direction of the
arrow to "O". Before cutting off the compressed air sup-
ply, always set the rotary valve to the "O" position so that
the tool cannot be reactivated inadvertently.
Always turn until the limit stop is reached. Do not
set the tool to any positions between those speci-
fied!
2.3 r
Ating dAtA
Pressure
Power output
Air consumption full load EN ISO 15744
Air consumption at idling EN ISO 15744
Setting oiler idle
No-load speed
Max. wheel diameter
Collet chuck Ø
Sound pressure level EN ISO 15744 68dB(A), K=3dB(A)
Vibration EN ISO 28927-12
Air quality DIN ISO 8573-1
Weight with hose
2.4 o
PerAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
andlIng
3.1 t
ools
Observe the tool manufacturers instructions!
Only tools with a diameter of smaller than 10 mm may be
used.
max. 6.3bar
220W
3
0.66m /min
3
0.29m /min
about 1 drops/min
-1
92'000min
10mm
3mm / 1/8"
2 2
2.4m/s , K=1.0m/s
2/4/4
0.450kg
/o
peratIon