VelLight XMPL10RGB Manual Del Usuario página 4

5. Fold the gasket back up around the base of the lamp. Make sure that the gasket fits evenly. The
gasket must not be crinkled.
6. Repeat for each lamp holder.
Testing
When each lamp holder has a lamp fitted and the gaskets are correctly placed, test the chain before
installing it.
1. Plug the chain into a suitable power socket.
2. Check if all lamps are working.
If yes, you can proceed with the installation.
o
If no, disconnect the chain from power and replace any faulty lamps.
o
Caution: if the problem persists, do not use the chain and contact your dealer.
Installation
There must be a lamp fitted in each lamp holder, and each lamp must be sealed correctly
with its gasket. It is not safe to use the chain with missing or incorrectly placed lamps or
gaskets.
To install the chain after testing, proceed as follows:
1. Choose a suitable mounting spot. Make sure that the chain cannot get damaged, for example by
sharp edges, swinging windows, doors, etc. Also make sure that the chain cannot cause hazardous
situations if it accidentally comes loose. For example, avoid crossing passageways. Not suitable for
installation in cabinets, ceilings, or other enclosures. Not suitable for installation under water.
2. To mount the chain, start at the side of the power plug. Position the power plug near a mains outlet,
but do not plug it in yet. Make sure to leave enough power cable to easily plug into the mains
outlet without stress on the cable.
3. Start mounting the chain in the desired location.
Caution: make sure not to damage the insulation during installation. Do not use sharp tools
to install the chain. Do not fix the chain to buildings or other supports using nails, staples, or
other sharp, conducting materials.
4. It is recommended to fix the chain to a support at least every metre.
6. Use
1. Plug the chain into a suitable mains outlet to switch it on.
2. Unplug it from the mains to switch off.
7. Maintenance

Once a month, inspect the plug, cable, insulation, and lamp holders for degradation due to weather,
UV light, or other damage. If you notice any deterioration, stop using the chain and dispose of it.

If a lamp is not working, unplug the chain immediately and replace the lamp. See Fitting or
Replacing Lamps for detailed instructions. Use only replacement lamps of the exact same type as
stated in the specifications in this manual.
V. 01 – 01/04/2014
XMPL10RGB/XMPL10WW
OK
4
Not OK
©Velleman nv