Casselin CBMECS1 Manual De Instrucciones página 14

5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
5.2 Use
WARNING
The setting up of the device installation and maintenance should only be carried out by professionals.
• Do not leave the appliance running without watching it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
Remove the product from its packaging.
Clean the device with warm water and a clean cloth, then dry the device completely with a soft, dry cloth.
Place the unit upright on a solid, flat surface; never place it on a flammable surface.
Do not install it near a heating device.
On first use: fill the water tank to the level indicated.
Plug in the device and turn it on with the switch.
Set your temperature and let it run for 10 min.
Let the appliance cool down, unplug it and empty the water from the tank.
Fill the water tank again to the indicated level. Put the food in the basket.
Close the lid.
Plug in the device and turn it on with the switch. Set your temperature.
The green light comes on when heating and when the desired temperature is reached, it goes out.
The water level must be checked regularly, the appliance must never be operated without water.
REMARK
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
6. CLEANING AND MAINTENANCE
EN