Publicidad
EN
4
SAFETY INSTRUCTIONS
The garden furniture and its parts were made of aluminium in combination
with textile material. Garden furniture is exposed to environmental influences
such as large temperature fluctuations, humidity and intensive sunlight. In
order to enjoy your garden furniture longer, you should follow the following
instructions:
•
Avoid prolonged contact with moisture and standing water. Take your
furniture inside in the rain or cover it with a protective cover. In case of
short rain showers, tilt the furniture slightly after the rain and wipe off the
moisture. If you cover the furniture for a longer period of time, make sure
that there is sufficient air circulation.
•
We recommend leaving the cushion covers on the cushion during cleaning
instead of removing them. Clean the outer cushion cover with clean
water and a soft brush. Remove stubborn dirt with a little soapy water
and then wipe with a clean cloth and clear water. Allow the pillows to air
dry completely after cleaning or before storage. Never put them in the
washing machine or dryer.
•
Avoid contact with sunscreen or tanning products.
•
The screws are made of stainless steel for greater durability. Do not
overtighten the screws.
•
The frame is powder-coated. Use and transport can cause damage to the
coating. Repair this immediately with a dab of paint to prevent rust.
•
When not in use, protect the garden furniture from excessive sunlight,
otherwise the colour may fade.
•
Store the garden furniture in winter in a cool, dry and frost-free place. The
garden furniture is not winterproof.
•
Please use individual parts only for sitting or lying. They are not suitable as
a replacement for a ladder or as gymnastics equipment for children.
•
The garden furniture and all related parts are for private use only.
Note: Chairs and sunbeds can be loaded up to 100 kg, two-seater benches
up to 160 kg and three-seater benches up to 240 kg.
HINTS FOR ASSEMBLY
•
Put the parts together on a carpet so that they are not damaged during
assembly.
•
Do not tighten the screws until all screws of the component are in the
correct position.
Publicidad
