use. Additional fasteners/clamps are not included in the kit. Moreover, the
wires should run parallel to each other and none of them can come into contact
with the other.
6) At the other end of the red power cord there is a crocodile clip (F) - connect it
to the fence wire.
7) After completing the installation and making sure that no wire is broken or in
contact with another, you can connect the controller (A) to the power source.
For power supply use: a cable with crocodile clips to the 12V battery ("+" red;
"-" black ").
8) After connecting the power supply, if the entire installation has been carried
out correctly, the control lamp should light up - it means that the device is
working, i.e. the fence is live.
3.3.
Cleaning and maintenance
a)
Before any cleaning, repair or modification of the fence or replacement of
accessories, and also when the device is not in use, disconnect the power plug.
b)
Store the device controller in a dry and cool place, protected from moisture
and direct sunlight.
c)
It is forbidden to spray the controller with a stream of water or immerse it in
water.
d)
Make sure that no water enters through the ventilation openings in the casing.
e)
Clean the ventilation openings with a brush and compressed air.
f)
Perform regular inspections of the unit checking technical fitness and any
damages.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this appliance
are recyclable according to their marking. By reuse, recycling or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.