Publicidad
Idiomas disponibles
Idiomas disponibles
11A
0° 15° 22,5° 30° 45° 60°
0° 15° 22,5° 30° 45° 60°
4
Setting individual mitre angles
► Release the rotary knob
► Press the detent lever
to place by pressing on it at the left.
► Continuously swivel the rotary base into the
required position
► Close the rotary knob
.
and let it click in
.
.
11B
4
10.8 Sawing inclined cuts [12]
Moving or removing the stop rulers
may make it necessary to implement special
settings for inclined cutting, see section 9.6.
Inclination to the left between 0° and 45°
► Loosen the star handle
► Tilt the saw unit to the required cutting an
gle
.
► Tighten the star handle
Inclination to the right between 0° and 45°:
► Loosen the star handle
► Press the release button
relieve the tension by slightly tilting it in the
opposite direction.
► Tilt the saw unit to the required cutting an
gle
.
► Tighten the star handle
46–47° inclination to the right/left
(undercutting)
► Loosen the star handle
► Press the release button
relieve the tension by slightly tilting it in the
opposite direction.
► Tilt the saw unit to the limit stop
► Press the release button again
► Tilt the saw unit again
English
0 - 60°
0 - 60°
.
.
.
; if required,
.
.
; if required,
.
.
.
23
Publicidad
