Publicidad
Idiomas disponibles
Idiomas disponibles
Information on indexing gear
Switch off the motor.
Wait for standstill.
Adjust required speed. (see fig. 4).
ATTENTION! Never change the speed drive during operation.
When changing the speed, it is recommended to turn slightly by hand the output shaft (drill
bit holder), in order to enable the gear teeth to thread.
Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow the instructions
during operation.
Do not modify the machine or the machine tools and accessories after receipt. Any
constructive changes or modifications need the manufacturer`s acceptance and have to be in
compliance with the safety instructions. Use the machine only for its determination. Consider
the technical data of the equipment and the ambient temperatures. Pay attention to labels,
restrictions of use and special instruction notes on the machine tools and the machine itself.
Check regularly that the type plate and symbols on the machine are legible. If necessary,
contact the manufacturer to replace them. Only operators with technical knowledge, trained by
authorized responsible technical personnel, may install, adjust, operate, transport and store the
machine.
Generally, the employer is responsible for the faultless condition/operation of the machine
and the adherence to the safety regulations. The machine is designed and manufactured
according to the technical safety regulations. However, using it, there is still a risk of accidents
to the operator or third parties or damage to the machine or other objects. All current regulations
and specifications, which apply to the site of operation in regards to accident prevention,
installation of electrical and mechanical systems as well as radio interference must be
considered.
IMPORTANT • The employer must make sure that...
•
risk assessment is carried out for the specific risks, which can occur due to any operation of
the machine,
•
the function of the safety equipment is regularly checked,
•
the safety symbols and safety notes on the machine/ device and the operating instruction
booklet are considered,
•
the safety instructions and the operating instruction booklet are available completely and in
legible condition on site with the machine.
The employer is obliged to allow personnel to work on the machine only, who:
36
BASIC SAFETY INSTRUCTIONS
EMPLOYER'S OBLIGATIONS
Publicidad
